The experience of operating riveted vessels also testifies to the pliability of rivet seams. Previously, when the cross-sectional area of the rivets in the joints of the outer skin was smaller than it is now, the butt seams of the wide track often diverged. The sheets of the wide track and the butt strips remained intact, and the sheets below the wide track, directly under the joint of the wide track, were torn. Thus, as a result of the shift in the rivet seam of the shirstreak, there was a redistribution of stresses in the housing, from which the shirstreak was unloaded and the adjacent belt was additionally loaded.


Only the shear of the butt joints can explain the satisfactory operation of the light bulwarks of riveted vessels attached to the shipwreck, as a result of which such bulwarks do not strain to the same extent as the bulwarks of welded vessels, and therefore cracks rarely appear in them.


Riveted seams made on welded vessels proved to be able to prevent the spread of cracks. To date, no cases of crack propagation on welded vessels through riveted seams have been known from operational practice.


Cracks continued to appear in the corners of the long cabins. The breakage of the corners of the cabins was accompanied by the spread of cracks on the walls of the cabins and deck plates. These cracks rarely reached dangerous sizes, however, the waterproofness of the deck and deckhouse was violated. In order to reduce the undesirable stress concentration in the corners, it was proposed to install the ends of the felling on rivet joints. The elastic riveted joint made it possible to reduce the rigidity of the felling connection, as a result of which the corners stopped breaking off. The design of the corner of such a cabin with a riveted gable is shown in the project.


Thus, practically on welded vessels, the area of the corners of deck cutouts continues to be the only dangerous area to this day. From the point of view of the working conditions of intermittent connections, it would be advantageous to make riveted seams along the AB and CD lines in the area between the cutouts in the sheets, and to fix the corners of the cut-out coamings with rivets, as in the case of felling. Indeed, the stress concentration from the longitudinal bending of the vessel in the corners of the cutouts supported by the coamings is the result of the action of two shear stress systems acting along the line of contact of the longitudinal coamings to the deck deck and along the AB and CO lines. The first system is the result of the resistance of the longitudinal coamings to elongation as separate beams, and the second is the result of a shift along the line of the longitudinal coamings between the hatches.


The maximum value of the shear stresses of the first and second systems will be at the very corners of the cutouts. These shear stresses cause additional normal stresses in the deck areas, which are the cause of stress concentrations. The riveted elastic joint, which is malleable, promotes the free elongation of the fibers of the continuous part and makes it possible to reduce the concentration in the corners of the discontinuous bond compared to a structure made by welding. Mobilne granie jeszcze nigdy nie było tak proste jak z aplikacja salon gier dla każdego użytkownika.